Help on Dash removal to access Central Door Locking Module

Topics relating to the Lotus Exige S2 (series 2)
Post Reply
fangio246
Reactions:
Posts: 9
Joined: Thu Feb 02, 2017 3:44 pm

Hi All

I've got a 2010 Exige and the both doors will lock with the key fob, however when you push to open on the key fob the passenger door unlocks but the drivers side doesn't….

I have had the drivers door actuator out and 12 volts across it and it opens and closes the actuator ok depending on the polarity.

Have put a meter across the supply to the drivers door actuator and when closing the reading is around 12 volts, however when opening it's in the 1 to 3 volt range or less!

Lotus Cars have suggested it is probably a faulty Central Door Locking Module but this requires removal of the dash to access...

Any other ideas and anyone got a manual including how to remove the dash or diagram I can get?

Thanks in advance
jfk
Reactions:
Posts: 3254
Joined: Wed Jul 30, 2008 9:50 pm
Location: Dudlaay.

Most people don't remove the dash ..
There's room to get the new one in and just use double sided tape to piggyback it to the old one
Burstner/Ducato Motorhome
fangio246
Reactions:
Posts: 9
Joined: Thu Feb 02, 2017 3:44 pm

Hi JFK
So you can get your hand in to unplug and remove existing module without loosening or removing anything - Dash etc?

Roughly do you know where to go, say in relationship to the steering column?

Many thanks
Andy
jfk
Reactions:
Posts: 3254
Joined: Wed Jul 30, 2008 9:50 pm
Location: Dudlaay.

Burstner/Ducato Motorhome
Post Reply