big bore 'crush type' exhaust gasket

[The Hornet]

I have a 2bular manifold (its at least 8 years old) - So as part of my engine rebuild, Hangar 111 used a Lotus/Toyota gasket, originally, but with the issues with the replacement block, they also noticed that the std gasket was blowing a bit, so are asking me to get hold of a larger bore one - I will go directly to Jim if needed, but anyone know where I could get one ?

Thanks in advance

[andybond]

Any idea of the dimensions? There must be loads on ebay?

[Fonzey]

Do you mean the manifold to engine gasket or the donut gasket to the cat?

My 2bular supplied engine gasket blew like a trooper and was nowhere near the right size for the notes, but a legit toyota one fits and seals perfect.

I'm also on the hunt for a donut gasket for when the car goes back together but I was half sure it was the same size as oem needed?

[The Hornet]

It’s defo the exhaust manifold gasket, h111 said the std one was blowing, so they need one that fits a 2bular manifold.. the opposite to you then !

[Fonzey]

I would take H111's word over mine!

Obviously things change a lot over time, I know the 2bular stuff has gone through many iterations over the years so perhaps the situations are not comparable.