Help on Dash removal to access Central Door Locking Module

Topics specific to owners of the series 2 Exige
fangio246
Posts: 9
Joined: Thu Feb 02, 2017 3:44 pm

Help on Dash removal to access Central Door Locking Module

Post by fangio246 » Tue Sep 18, 2018 10:12 am

Hi All

I've got a 2010 Exige and the both doors will lock with the key fob, however when you push to open on the key fob the passenger door unlocks but the drivers side doesn't….

I have had the drivers door actuator out and 12 volts across it and it opens and closes the actuator ok depending on the polarity.

Have put a meter across the supply to the drivers door actuator and when closing the reading is around 12 volts, however when opening it's in the 1 to 3 volt range or less!

Lotus Cars have suggested it is probably a faulty Central Door Locking Module but this requires removal of the dash to access...

Any other ideas and anyone got a manual including how to remove the dash or diagram I can get?

Thanks in advance

jfk
Posts: 3252
Joined: Wed Jul 30, 2008 9:50 pm
Location: Dudlaay.

Re: Help on Dash removal to access Central Door Locking Modu

Post by jfk » Tue Sep 18, 2018 3:07 pm

Most people don't remove the dash ..
There's room to get the new one in and just use double sided tape to piggyback it to the old one

fangio246
Posts: 9
Joined: Thu Feb 02, 2017 3:44 pm

Re: Help on Dash removal to access Central Door Locking Modu

Post by fangio246 » Wed Sep 19, 2018 3:44 pm

Hi JFK
So you can get your hand in to unplug and remove existing module without loosening or removing anything - Dash etc?

Roughly do you know where to go, say in relationship to the steering column?

Many thanks
Andy

jfk
Posts: 3252
Joined: Wed Jul 30, 2008 9:50 pm
Location: Dudlaay.

Re: Help on Dash removal to access Central Door Locking Modu

Post by jfk » Wed Sep 19, 2018 7:14 pm


Post Reply